11/12/2022 0 Comments 8192cu driver as ap and station![]() ![]() This could be switched based on your setup, and may change after a restart. In this case, wlan0 is the internal device and wlan1 is the USB dongle. setting the interface in master mode using the wireless-tools provided by realtek still works. Tx excessive retries:0 Invalid misc:0 Missed beacon:0 So, short recap: the stock 8192cu driver that comes with wheezy was working fine in managed and master mode, and it is still working fine, after the reflashing, but in managed mode only (e.g., to connect to another access point). #8192cu driver as ap and station how to#Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 In this tutorial, we demonstrate how to enable WiFi drivers and networking for the. ![]() Link Quality:0 Signal level:0 Noise level:0 Mode:Auto Frequency=2.412 GHz Access Point: Not-Associated Retry short limit:7 RTS thr:off Fragment thr:off 8192cu: CONFIGAPMODE hardcoded in autoconf.h diff -git a/drivers/net/wireless/Kconfig b/drivers/net/wireless/Kconfig index f9f9422. I am facing the same troble with your met about the wifi ap mode. Mode:Managed Access Point: Not-Associated Tx-Power=31 dBm 8192cu needs old wireless extensions The obsolete WIRELESSEXT configuration is used by the old Realtek code and is needed for AP support. We integrated rtl8192cu driver from another package, we used manual. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |